NHTSA lists 5 safety recalls covering the 1995 Mitsubishi Galant. Open recalls don't stop you from selling or junking the car, but check your VIN at nhtsa.gov/recalls to see which apply to yours.
SuspensionDec 2000 · NHTSA campaign 00V421001
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude. Also, mmc has added the potential of leaking moisture, which can cause the ball stud to corrode.
Risk: This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash. This campaign supercedes mmc's previous safety recall campaign, see 99v-066.
Fuel System, GasolineAug 2000 · NHTSA campaign 00V237000
Vehicle description: passenger vehicles. Cracks can occur in the top of the fuel tank due to an improper spot weld on the baffle plate to the top portion of the fuel tank.
Risk: A crack in the fuel tank could allow fuel or fumes to escape. Fuel leakage, in the presence of an ignition source, could result in a fire.
SuspensionApr 1999 · NHTSA campaign 99V066001
Vehicle description: passenger vehicles. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude.
Risk: This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash.
SuspensionApr 1999 · NHTSA campaign 99V066002
Vehicle description: passenger vehicles built in japan. If the rubber boots on the lower lateral arm ball joints of the front suspension were damaged during assembly, dirt and water can intrude.
Risk: This condition could cause the lower lateral arm ball joint to separate, increasing the risk of a vehicle crash.
Exterior LightingSep 1998 · NHTSA campaign 98V212000
Vehicle description: passenger vehicles. When the stop lamp switch was assembled, grease was inadvertently applied to the contact point. This can cause the contact point to heat up causing internal operation elements to melt allowing the swtich to become stuck in on or off position.
Risk: This condition can cause the anti-lock braking system (ABS) warning light to come on.