NHTSA lists 8 safety recalls covering the 2000 Lincoln Town Car. Open recalls don't stop you from selling or junking the car, but check your VIN at nhtsa.gov/recalls to see which apply to yours.
VisibilityAug 2001 · NHTSA campaign 01V258000
Vehicle description: passenger cars, sport utility vehicles, and light and medium duty pickup trucks. A switch located in the plastic cover of the wiper motor gear case could malfunction and overheat, potentially resulting in loss of intermittent wiper function, loss of wiper park function, complete loss of wiper function, or…
Risk: Loss of visibility while driving increases the risk of a crash.
TiresDec 2000 · NHTSA campaign 00V356000
Vehicle description: certain limousines stretched over 60 inches fail to comply with the requirements of fmvss no. 109, "new pneumatic tires," and no. 110, "tire selection and rims."
Risk: The vehicle weight could exceed the maximum load rating for the tire, increasing the risk of premature tire wear or blowout.
Seat BeltsNov 2000 · NHTSA campaign 00V364000
Vehicle description: certain passenger vehicles with medium graphite seat belts fail to comply with the requirements of fmvss no. 209, "seat belt assemblies." an incorrect front center seat belt and retractor assembly may have been installed.
Risk: In the event of a vehicle crash, the occupant may not be properly restrained.
Seat BeltsNov 2000 · NHTSA campaign 00V368000
Vehicle description: passenger vehicles with midnight black or medium parchment seat belts manufactured on july 31, 2000, fail to comply with the requirements of fmvss no. 209, "seat belt assemblies." an incorrect driver's side rear seat belt and retractor assembly may have been installed.
Risk: In the event of a vehicle crash, the occupant may not be properly restrained.
Seat BeltsAug 2000 · NHTSA campaign 00V228001
Vehicle description: passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat…
Risk: In the event of a vehicle crash, the occupant may not be properly restrained.
EquipmentJul 2000 · NHTSA campaign 00V200000
Vehicle description: passenger vehicles. These vehicles have jacking instructions which, if followed, could cause the vehicle operator to place the jack on a frame weld when attempting to raise a rear wheel. If the vehicle is jacked up with the jack placed on the frame weld and if the vehicle is free to roll (wheels not blocked or…
Risk: If this occurs and any portion of the operator's body is under the vehicle, the potential for personal injury exists.
Seat BeltsJun 2000 · NHTSA campaign 00V157001
Vehicle description: passenger vehicles using aftermarket driver's seat belt assemblies that were sold by ford parts departments from january 1, through june 13, 2000. These seat belt assemblies fail to comply with the requirements of fmvss no. 209, "seat belt assemblies." the equipment involved is service stock seat belt assemblies…
Risk: In the event of a collision, these seat belts may not restrain an occupant increasing the risk of injury.
Seat BeltsJun 2000 · NHTSA campaign 00V157002
Vehicle description: passenger vehicles using aftermarket front passenger side seat belt assemblies that were sold by ford parts departments from january 1, through june 13, 2000. These seat belt assemblies fail to comply with the requirements of fmvss no. 209, "seat belt assemblies." the equipment involved is service stock seat belt…
Risk: In the event of a collision, these seat belts may not restrain an occupant increasing the risk of injury.